300-410 Exam: Absolutely Free Online Practice

Question 1
- Refer to the exhibit.
  Router R2 should be learning the route for 10.123.187.0/24 via EIGRP. Which action resolves the issue without introducing more issues?
  
  A : Use distribute-list to modify the route as an internal EIGRP route
  
  B : Redistribute the route in EIGRP with metric, delay, and reliability
  
  C : Use distribute-list to filter the external router in OSPF
  
  D : Remove route redistribution in R2 for this route in OSPF
  
  Answer: C
Question 2
- Refer to the exhibit.
  An engineer must configure a LAN-to-LAN IPsec VPN between R1 and the remote router. Which IPsec Phase 1 configuration must the engineer use for the local router?
  
  A : crypto isakmp policy 5
  authentication pre-share
  encryption 3des
  hash sha
  group 2
  !
  crypto isakmp key cisco123 address 200.1.1.3
  
  B : crypto isakmp policy 5
  authentication pre-share
  encryption 3des
  hash md5
  group 2
  !
  crypto isakmp key cisco123 address 200.1.1.3
  
  C : crypto isakmp policy 5
  authentication pre-share
  encryption 3des
  hash md5
  group 2
  !
  crypto isakmp key cisco123 address 199.1.1.1
  
  D : crypto isakmp policy 5
  authentication pre-share
  encryption 3des
  hash md5
  group 2
  !
  crypto isakmp key cisco123! address 199.1.1.1
  
  Answer: A
Question 3
- Which IGPs are supported by the MPLS LDP autoconfiguration feature?
  
  A : RIPv2 and OSPF
  
  B : OSPF and EIGRP
  
  C : OSPF and ISIS
  
  D : ISIS and RIPv2
  
  Answer: C
Question 4
- What is the purpose of an OSPF sham-link?
  
  A :
  to allow intra-area routing when OSPF is used as the PE-CE connection protocol in an MPLS VPN network
  
  B :
  to correct OSPF backdoor routing when OSPF is used as the PE-CE connection protocol *i an MPLS VPN network
  
  C :
  to correct OSPF backdoor routing when OSPF is used as the PE-PE connection protocol m an MPLS VPN network
  
  D :
  to allow inter-area routing when OSPF is used as the PE-CE connection protocol in a MPLS VPN network
  
  Answer: C
Question 5
- A customer reports that traffic is not passing on an EIGRP enabled multipoint interface on a router configured
  as below:
  interface Serial0/0
  no ip address
  interface Server0/0/0.9 multipoint
  ip address 10.1.1.1 255.255.255.248
  ip split-horizon eigrp 1
  Which action resolves the issue?
  A : Enable poison reverse
  
  B : Enable split horizon
  
  C : Disable poison reverse
  
  D : Disable split horizon
  
  Answer: D

Free Cisco 300-410 Exam Questions

Absolute Free 300-410 Exam Practice for Comprehensive Preparation