Absolute Free AD01_OP Exam Practice for Comprehensive Preparation 

A Blue Prism solution works fine when developing and testing it in Process and Object Studio, but when it is run in Control Room, exceptions occur because elements are not being found. What is the most likely cause of this behaviour? 

The Blue Prism Work Queue named “Customer Onboarding” has a number of Pending Items which may be tagged as “Domestic”, “Retail” or “Business”. There is also a tag for the 8 digit product code formatted as “Product Code: {product code}” e.g. Product Code: CA123456. What is the correct configuration for the ‘Tag Filter’ input parameter, to get the next item from the queue that: 1. Isn’t applying for a loan product i.e. Product Code doesn’t begin with “LN” and 2. Is a domestic customer

Study the following Process flow: 

The Process flow is intended to test the value of the Input data item to determine if it falls within a range of numbers, and then assign a value as an output. The number ranges are defined as between 1 to 100, between 101 to 200, and anything outside these ranges. The Calculation stages will set the value of the Result data item to 1, 2 or 3. To enable the Process flow to work correctly, what is the correct expression for the Choice stage branch named ‘Between 1 and 100’?

This is the Mam Page of a simple process which calls the Page Calculation before completing The data items

are configured as follows:

• X is a Number data item with an initial value of 20

• Y is a Number data item with an initial value of 5

• Result is a Number data item with no initial value

The Calculation Page stage is configured as follows: 

The Calculation Page is as follows:

The Data Items are configured as follow:

• X is a Number data item with an initial value of 10

• Y is a Number data item with an initial value of 5

• Result is a Number data item with no initial value

The Start Stage is configured pass through the X and Y values as input parameters.

The divide calculation stage expression is [X] / [Y]

The end stage is configured to pass back the results value as an output parameter.

What will be contained in the Result Data Item on the Mam Page following the execution of the Process?